Limited Rotation Hydraulic Motor

{0 Comments}

A limited rotation hydraulic motor provides a rotary output motion over a finite angle. This device produces a high instantaneous torque in either direction and requires only a small amount of space and simple mountings.

Rotary motors consist of a chamber or chambers containing the working fluid and a movable surface against which the fluid acts. The movable surface is connected to an output shaft to produce the output motion.

Figure 4.1 shows a direct acting vane-type actuator. In this type, fluid under pressure is directed to one side of the moving vane, causing it to rotate. This type of motor provides about 280° rotation.

 Limited Rotation Hydraulic Motor

Rotary actuators are available with working pressures up to 350 kg/cm3 (4978 psi). They are typically foot mounted, flanged or end mounted. Most designs provide cushioning devices. In a double vane design similar to the one depicted in the figure above, the maximum angle of rotation is reduced to about 100°. However in this case, the torque-carrying capacity is twice that obtained by a single vane design.

Leave a Comment

Your email address will not be published.