Remove the two bolts and nuts (Item 1) and remove the bracket (Item 2) [Figure 20-100-3]. Remove the straight fitting (Item 1) and 90° fitting…

Open the rear door. Disconnect the electrical connector (Item 1) [Figure 20-100-1] from the auxiliary hydraulic interlock valve. Remove the hose (Item 1) and tubeline…

The auxiliary hydraulic interlock valve has a single solenoid stem that is normally closed. The operation of the valve is controlled by an electric solenoid.…

Stop the engine and open the rear door. Remove the bolt (Item 1) and move the air cleaner indicator (Item 2) [Figure 20-90-1] out of…

The oil cooler cools the loaders hydraulic and hydrostatic oil. Oil passages are coiled into a heat exchanger. The cooling fan forces air around the…

Lift and block the loader. (See Procedure on Page 10-10-1.) Remove the fluid from the hydraulic reservoir. (See Removing And Replacing Hydraulic / Hydrostatic Fluid…

The hydraulic fluid reservoir is a storage container for the loaders hydraulic/hydrostatic fluid. The reservoir contains a vented fill cap with a fluid screen to…

Remove the filter (Item 1) [Figure 20-70-4]. Remove the temperature sender (Item 1) [Figure 20-70-5] from the filter block. Assembly: Apply thread sealer to the…

Put jackstands under the front and rear of the loader. (See Procedure on Page 10-10-1.) Raise the lift arms and install the lift arm support…

The hydraulic/hydrostatic filter helps to remove contaminants from the hydraulic fluid when the hydraulic/ hydrostatic systems are operating. The hydraulic/hydrostatic filter housing contains the charge…