BobCat S70 – LIFT ARM BY-PASS CONTROL VALVE – Removal And Installation

Install jackstands under the rear corners of the loader.

Raise the operator cab. (See Raising on Page 10-30-1.)

Remove the Remove the knob and washer (Item 1) [Figure 20-50-2].

Remove the two mounting bolts (Item 2) [Figure 20-50-2] securing the valve body to the control shield.

Remove the control shield mounting bolts (Item 3) [Figure 20-50-2].

Remove the tubelines (Item 1) and hose (Item 2) [Figure 20-50-3] to remove the by-pass body assembly.

Install plugs on the tubelines.

Leave a Reply

Your email address will not be published. Required fields are marked *