BobCat S70 – HYDRAULIC/HYDROSTATIC FILTER – Housing Removal And Installation

Put jackstands under the front and rear of the loader.
(See Procedure on Page 10-10-1.)

Raise the lift arms and install the lift arm support device.
(See Installing on Page 10-20-1.)

Raise the operator cab. (See Raising on Page 10-30-1.)

Disconnect the hose (Item 1) [Figure 20-70-1] from the filter block.

Disconnect the electrical connector from the charge pressure sender (Item 2) and the temperature sender (Item 3) [Figure 20-70-1].

Remove the drain hose (Item 1) [Figure 20-70-2] from the filter block.

Remove the inlet tubeline (Item 2) [Figure 20-70-2] from the filter block.

Remove the two mounting bolts (Item 1) [Figure 20-70-3] from the outside of the fender.

Remove the hydraulic filter block.

Leave a Reply

Your email address will not be published. Required fields are marked *