BobCat S70 – HYDRAULIC/HYDROSTATIC FILTER – Housing Disassembly And Assembly

Remove the filter (Item 1) [Figure 20-70-4].

Remove the temperature sender (Item 1) [Figure 20-70-5] from the filter block.

Assembly: Apply thread sealer to the threads of the temperature sender before installing.

Remove the charge pressure sender (Item 1) [Figure 20-70-6] from the filter block.

Install a new O-ring (Item 2) [Figure 20-70-6] on the charge pressure sender.

Remove the plug (Item 1) [Figure 20-70-7] from the filter block.

Remove the O-ring (Item 1) [Figure 20-70-8] from the plug.

Remove the fitting (Item 1) [Figure 20-70-9] from the filter housing.

Remove the poppet (Item 1) and spring (Item 2) [Figure 20-70-10] from the filter housing.



Leave a Reply

Your email address will not be published. Required fields are marked *