BobCat S70 – HYDRAULIC CONTROL VALVE – Tilt Spool Removal And Installation

Remove the lift and tilt lock block (Item 1) [Figure 20-40-61] from the control valve. (See Lift And Tilt Lock Block Removal And Installation on Page 20-40-12.)

Remove the bushing (Item 1) and O-ring (Item 2) [Figure 20-40-62] from the tilt spool linkage end.

Remove the end cap mounting screws (Item 1) and remove the end cap (Item 2) [Figure 20-40-63] from the tilt spool centering spring.

Assembly: Tighten the mounting screws to 90-100 in.-lb. (10,2-11,3 N•m) torque.

Remove the spool and centering spring assembly from the control valve [Figure 20-40-64].

 

Leave a Reply

Your email address will not be published. Required fields are marked *