BobCat S70 – HYDRAULIC CONTROL VALVE – BICS Valve, Check Valve Removal And Installation

Remove the check valve (Item 1) [Figure 20-40-10].

Installation: Tighten the valve to 22 ft.-lb. (30 N•m) torque.

Remove the O-rings (Item 1) and back-up ring (Item 2) [Figure 20-40-11] from the check valve.

Install new O-rings and back-up ring on the check valve.

Clean and inspect the screen (Item 1) [Figure 20-40-12] on the end of the valve.


Leave a Reply

Your email address will not be published. Required fields are marked *