BobCat S70 – HYDRAULIC CONTROL VALVE – Auxiliary Spool Removal And Installation

Remove the screws (Item 1) and rubber boot (Item 2) [Figure 20-40-69] from the linkage end of the control valve.

Remove the spool seal retainer (Item 3), and O-ring (Item 4) [Figure 20-40-69] from the control valve.

Assembly: Tighten the screws to 90-100 in.-lb. (10,2-11,3 N•m) torque.

Remove the two mounting screws (Item 1) and detent cap (Item 2) [Figure 20-40-70].

Remove the centering spring assembly (Item 1), detent retainer (Item 2), housing (Item 3), seal retainer (Item 4), and spool seal (Item 5) [Figure 20-40-71].

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *