BobCat S70 – CYLINDER (TILT) – Removal And Installation

Remove the attachment. Tilt the Bob-Tach fully forward until it rests on the floor. Stop the engine. Raise the seat bar.

Engage the parking brake.

Remove the bolt (Item 1) and the retainer (Item 2) [Figure 20-21-2] from the Bob-Tach and tilt cylinder rod end pivot pin.

Installation: Tighten the bolt to 18-20 ft.-lb. (24-27 N•m) torque.

Remove the pivot pin from the Bob-Tach.

Remove the hoses (Item 1) [Figure 20-21-3] from the tilt cylinder fittings.

Remove the bolt (Item 1) and the retainer (Item 2) [Figure 20-21-4] from the base end of the tilt cylinder.

Remove the pivot pin (Item 1) [Figure 20-21-5] from the tilt cylinder base end and the lift arm frame.

 

Leave a Reply

Your email address will not be published. Required fields are marked *