NOTE: Changes CANNOT be performed until the seat bar is lowered, the engine is started and the PRESS TO OPERATE LOADER button is pressed to enable the BICS.
Perform pre-starting and starting procedures:
1. Fasten seat belt.
2. Lower seat bar.
3. Place joysticks in neutral position.
4. Start the engine.
5. Press the PRESS TO OPERATE LOADER button.
NOTE: Raising the seat bar or changing drive control patterns (ISO / H) will cause the machine to disengage from steering drift compensation. The current settings will remain in effect until the STOP button is pressed (Keyless Panel) or the key is turned OFF (Key Switch Panel).
Press and hold the PRESS TO OPERATE LOADER button (Item 1) for three seconds. The current steering drift compensation setting will appear in the HOURMETER / CODE display (Item 2) [Figure 60-161-2].
Press the upper left button (Item 6) on the left joystick to adjust the machine left. [S-L01] (Item 3) through a maximum of [S-L10] will appear in the display (Item 2) [Figure 60-161-2]. The number will increase by one each time you press the button. The higher the number, the greater the amount of steering drift compensation to the left. Adjustments to steering drift compensation will be effective immediately.
Press the upper right button (Item 7) on the left joystick to adjust back toward center. The display will decrease down to neutral displayed as [S—-] (Item 4). Another press of the upper right button will cause [S-r01] (Item 5) to appear in the display (Item 2) [Figure 60-161-2]. The number will increase by one each time you press the button up to a maximum of [S-r10]. The higher the number, the greater the amount of steering drift compensation to the right. Adjustments to steering drift compensation will be effective immediately.
NOTE: The display will revert back to hourmeter after a brief period of time. The machine will remain in steering drift compensation and continue at the current setting. Pressing the upper left or upper right button on the left joystick will adjust steering drift compensation accordingly and cause the new setting to appear in the display.
