BOBCAT S130 – SERVICE PC (LAPTOP COMPUTER) – Connecting To The Remote Start Tool

The tools listed will be needed to do the following procedure:
MEL1563 or 6689779 – Remote Start Tool
MEL1565 – Service Tool Harness Control
MEL1566 – Service Tool Harness Communicator (Computer Interface)

NOTE: Make all connections with the key in the OFF position.

The Service PC (Item 1) with the Remote Start Tool (Item 2) [Figure 60-150-1]. When connected to the loader, the Service PC is used to monitor, conduct diagnostics, and upgrade software.

Connect the Service Tool Harness Communicator (MEL1566) (Item 3) [Figure 60-150-1] to the designated serial port on the Service PC.

NOTE: The recommended serial cable length should not exceed 15 feet. A serial cable longer than 15 feet will create a degraded signal causing communication errors.

Connect the other end to the connector on the Remote Start Tool.

Connect the remote start tool to the loader. (See REMOTE START TOOL KIT-MEL1563 on Page 10-60-1.)


Leave a Reply

Your email address will not be published. Required fields are marked *