BOBCAT S130 – SEAT BAR – Removal And Installation

Raise the seat bar (Item 1) [Figure 50-10-1].

Disconnect the seat bar sensor (Item 1) [Figure 50-10-2] from the cab harness.

Lower the seat bar.

Loosen the nut (both sides) at the front corners of the operator cab [Figure 50-10-3].

Remove the nuts and plates (both sides) [Figure 50-10-3].

Installation: Tighten the nuts to 40 – 50 ft.-lb. (54 – 68 N•m) torque.

Lift on the grab handle and bottom of the operator cab slowly until the cab is all the way up and the latching mechanism engages [Figure 50-10-4].

Remove the seat bar mounting nuts (Item 1) [Figure 50-10-5] (both sides).

Installation: Tighten the nuts to 28 ft.-lb. (38 N•m) torque.

Lower the operator cab. (See Lowering on Page 10-30-3.)

Remove the seat bar (Item 1) [Figure 50-10-6] from the operator cab.

Reverse the above procedure to install the seat bar into the operator cab.

 

Leave a Reply

Your email address will not be published. Required fields are marked *