BOBCAT S130 – SEAT BAR – Compression Spring Disassembly And Assembly

Turn the bolt (Item 1) [Figure 50-10-12] & [Figure 50-10-11] out of the clevis.

Assembly: Apply Loctite® #518 adhesive to the bolt threads. Adjust the compression spring by turning the bolt in past the end of the clevis three turns.

NOTE: For procedures requiring the use of Loctite® #518 adhesive, thoroughly clean and dry affected parts before the application of Loctite® #518.

Disassemble and assemble the seat bar compression spring and parts as shown in Fig. [Figure 50-10-11].

Bolt (Item 1)
Bushing (Item 2)
Spring (Item 3)
Clevis (Item 4)
Retaining Pin (Item 5)
Pin (Item 6)
Bushing (Item 7)

 

Leave a Reply

Your email address will not be published. Required fields are marked *