BOBCAT S130 – REAR DOOR – Removal And Installation

Disconnect the light harness connector (Item 1) [Figure 50-70-1] from the engine harness.

Remove both rear lights (Item 2) [Figure 50-70-1] from the door. (See Rear Removal And Installation on Page 60-60-2.)

Secure the chain hooks (Item 1) [Figure 50-70-2] to the door as shown.

Connect a chain hoist (Item 2) [Figure 50-70-2] to the lifting chain.

Remove the top and bottom door hinge mounting bolts (Item 1) [Figure 50-70-3] and nuts.

NOTE: Install the door stop (Item 2) and the door stop retainer (Item 3) [Figure 50-70-3] in the top hinge as shown.

Installation: Tighten the mounting bolts and nuts to 25 – 28 ft.-lb. (34 – 38 N•m) torque.

Lift the door away from the loader frame and put the door flat on the floor.

Reverse the removal procedure to install the rear door.


Leave a Reply

Your email address will not be published. Required fields are marked *