BOBCAT S130 – LUBRICATION SYSTEM – Oil Pan Removal And Installation

Remove the engine and hydrostatic pump assembly from the loader. (See Engine Removal And Installation on Page 70-10-8.)

The engine will have to be on an engine stand or suspended in the air safely to remove the oil pan.

Remove oil pan bolts securing oil pan (Item 1) [Figure 70-60-2]. Slightly tapping on the oil pan with a soft mallet will break loose the oil pan from the engine block.

Installation: Use a liquid gasket adhesive to the oil pan side of the oil pan gasket. Tighten oil pan bolts to 29 – 33 ft.-lb. (39 – 75 N•m) torque.

Remove the oil strainer (Item 1) and O-ring (Item 2) [Figure 70-60-2] from the engine block.

Installation: Apply oil to O-ring.


Leave a Reply

Your email address will not be published. Required fields are marked *