Stop the engine and open the rear door.
Drain the hydraulic fluid. (See Removing And Replacing Hydraulic Fluid on Page 10-120-2.)
Remove the mounting bolt (Item 1) and remove the hydraulic filter drip pan (Item 2) [Figure 20-80-1].
Disconnect the tubeline (Item 3) [Figure 20-80-1] from the filter housing.
Disconnect the temperature sender connector (Item 1) [Figure 20-80-2] from the filter housing.
Disconnect the wire connector (Item 2) [Figure 20-80-2] from the differential pressure switch on the filter housing.
Using MEL 1558 tool disconnect the oil cooler tubeline (Item 1) [Figure 20-80-3] from the filter housing.
Remove the two mounting screws (Item 1) [Figure 20-80-4] from the filter housing mounting bracket.
Installation: Tighten the mounting screws to 15 – 20 ft.-lb. (20 – 27 N•m) torque.
Remove the hydraulic filter housing and filter.
Reverse the removal procedure to install the filter housing and filter.
Stop the engine and open the rear door.
Drain the hydraulic fluid. (See Removing And Replacing Hydraulic Fluid on Page 10-120-2.)
