BOBCAT S130 – HYDRAULIC/HYDROSTATIC FILTERS – Charge Filter Housing Removal And Installation

Remove filter outlet hose (Item 1) and inlet hose (Item 2) [Figure 20-80-5].

Disconnect the electrical connector (Item 3) [Figure 20-80-5] from the charge pressure sender.

Disconnect the charge pressure tubeline (Item 1) [Figure 20-80-6] that connects to the control valve.

Disconnect the electrical connector (Item 2) [Figure 20-80-6] from the differential pressure sensor.

Remove the four mounting bolts (Item 1) [Figure 20-80-7].

Installation: Tighten the mount bolts to 25 ft.-lb. (34N•m) torque.

Remove filter assembly from the loader.

Charge filter assembly components:
1. Filter
2. Filter head
3. Differential pressure switch
4. Charge pressure sensor


Leave a Reply

Your email address will not be published. Required fields are marked *