BOBCAT S130 – HYDRAULIC FLUID RESERVOIR – Removal And Installation

Lift and block the loader. (See Procedure on Page 10-10-1.)

Start the engine. Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.)

Stop the engine.

Raise the operator cab. (See Raising on Page 10-30-2.)

Drain the hydraulic fluid reservoir [Figure 20-90-1]. (See Removing And Replacing Hydraulic Fluid on Page 10-120-2.)

Mark and disconnect the hoses (Item 1) [Figure 20-90-2] from the hydraulic fluid reservoir.

Remove the hydraulic reservoir bracket (Item 1) by removing the two mounting bolts (Item 2) [Figure 20-90- 3].

Installation: Tighten the mounting bolts to 15 – 20 ft.-lb. (20 – 27 N•m) torque.

Remove the reservoir.


Leave a Reply

Your email address will not be published. Required fields are marked *