BOBCAT S130 – HYDRAULIC CONTROL VALVE (STANDARD) – End Cap/Spool Lock Block Removal And Installation

Remove the lift spool lock solenoid (Item 1) and the tilt spool lock solenoid (Item 2) [Figure 20-40-43] from the end cap/spool lock block.

Disconnect the tube line (Item 1) [Figure 20-40-44] from the end cap/spool lock block.

Remove the four end cap/spool lock block mount screws (Item 1) [Figure 20-40-45].

Installation: Tighten the screws to 90 – 100 in.-lb. (10 -11,3 N•m) torque.

Remove the rubber boots and retainer plate from the lift and tilt spools.

Remove the end cap/spool lock block (Item 1) [Figure 20-40-46] from the control valve.

 

Leave a Reply

Your email address will not be published. Required fields are marked *