BOBCAT S130 – HYDRAULIC CONTROL VALVE (ACS) OR (SJC) – Lift Load Check Valve Removal And Installation

Remove the tubeline (Item 1) [Figure 20-41-27] from the control valve.

Remove the fitting (Item 1) [Figure 20-41-28] from the check valve.

Remove the lift load check valve (Item 2) [Figure 20-41-28].

Installation: Lubricate the O-ring and tighten the valve to 55 – 65 ft.-lb. (75 – 88 N•m) torque.

Remove and install new O-rings (Item 1) and back-up ring (Item 2) [Figure 20-41-29].

Check for free movement of the load check valve (Item 1) [Figure 20-41-30].


Leave a Reply

Your email address will not be published. Required fields are marked *