BOBCAT S130 – HYDRAULIC CONTROL VALVE (ACS) OR (SJC) – End Cap Block Removal And Installation

Remove the lift and tilt actuators from the control valve.

Disconnect the tube line (Item 1) [Figure 20-41-50] from the end cap block.

Remove the two end cap block mount screws (Item 2) [Figure 20-41-50].

Installation: Tighten the screws to 90 – 100 in.-lb. (10 – 11,3 N•m) torque.

Remove the end cap block (Item 1) [Figure 20-41-51] from the control valve.


Leave a Reply

Your email address will not be published. Required fields are marked *