BOBCAT S130 – FUEL TANK – Removal And Installation

Remove the cover (Item 1) [Figure 50-80-1] which is installed over the fuel drain near the rear of the chaincase.

Installation: Tighten the cover mounting bolts to 15 – 20 ft.-lb. (20 – 27 N•m) torque.

Drain the fuel from the tank through the fuel drain (Item 1) [Figure 50-80-2].

Open the rear door of the loader.

Remove the engine/hydrostatic pump assembly from the loader. (See Engine Removal And Installation on Page 70-10-8.)

Disconnect the fuel fill hose (Item 1) and the vent hose (Item 2) [Figure 50-80-3] from the fuel tank.

Remove the fuel supply and return hoses (Item 1) [Figure 50-80-4].

Lift the fuel tank (Item 2) [Figure 50-80-4] and remove from the loader.

Reverse the removal procedure to install the fuel tank.

 

Leave a Reply

Your email address will not be published. Required fields are marked *