BOBCAT S130 – ENGINE SPEED CONTROL – Removal And Installation

Raise the lift arms and install an approved lift arm device. (See Installing on Page 10-20-1.)

Raise the operator cab. (See Raising on Page 10-30-2.)

Remove the two mounting screws (Item 1) [Figure 70-20-1] from the speed control mounting bracket.

Installation: Tighten screws to 15 – 20 ft.-lb. (20 – 27 N•m) torque.

Installation: Tighten the mounting bolts (Item 2) [Figure 70-20-1] evenly until the speed control lever moves back and forth at a comfortable tension.

Pull the speed control away from the loader frame and disconnect the speed control rod (Item 1) [Figure 70-20-2] from the control.

Installation: Be sure to install the speed control rod in the bottom hole of the speed control lever.

Installation: Install the stop bracket (Item 1) [Figure 70-20-3] in the same location. It is necessary for the front and rear stop on the bracket to be located correctly.

Reverse the removal procedure to install the engine speed control.


Leave a Reply

Your email address will not be published. Required fields are marked *