BOBCAT S130 – ENGINE COOLING SYSTEM – Fan Removal And Installation

Remove the lock nut and spacer (Item 1) [Figure 70-50-14].

Installation: Tighten the nut to 45 – 55 ft.-lb. (61 – 75 N•m) torque.

Use the following procedure to remove the fan from the shaft:

Install the nut (Item 1) [Figure 70-50-15] on the tapered shaft to protect the shaft and threads.

Install the puller on the fan as shown [Figure 70-50-15].

As the center bolt (Item 2) [Figure 70-50-15] is tightened, periodically strike the bolt head to loosen the fan from the shaft.

Remove the fan from the tapered shaft [Figure 70-50-15].


Leave a Reply

Your email address will not be published. Required fields are marked *