BOBCAT S130 – DRIVE BELT – Tensioner Pulley Disassembly

Remove the grease cover (Item 1) [Figure 30-60-11].

Remove the bolt (Item 1), the flat washer (Item 2), the retainer washer (Item 3), the spring washer (Item 4) and the second retainer washer (Item 3) from the pulley assembly (Item 5) [Figure 30-60-12].

Remove the two pins (Item 1) from the hub assembly (Item 2) [Figure 30-60-13] only if they have been damaged.

Remove the bracket assembly (Item 3) by tapping on the shaft (Item 4) [Figure 30-60-13] with a plastic hammer.

Remove the spring (Item 1) from the bracket (Item 2) [Figure 30-60-14].


Leave a Reply

Your email address will not be published. Required fields are marked *