BOBCAT S130 – DRIVE BELT – Tensioner Pulley Assembly

Install the spring (Item 1) on the pulley (Item 2) [Figure 30-60-15] as shown.

Install the shaft from the bracket assembly (Item 1) into the pulley assembly (Item 2) and align the spring (Item 3) [Figure 30-60-16] over the alignment pin on the bracket.

Turn the pulley assembly over and install the two pins (Item 1) [Figure 30-60-17] into the hub.

Install a punch as shown and turn clockwise while applying down pressure on the pulley.

Turn until the pulley snaps down into place; this procedure winds the spring and retains the end of the spring in proper location [Figure 30-60-18].

Install the first retainer washer (Item 1) and spring washer (Item 2) [Figure 30-60-19] over the roll pins.

Install the second retainer washer (Item 1), the washer (Item 2) and the bolt (Item 3) [Figure 30-60-20]. Tighten the bolt to 28 – 32 ft.-lb. (38 – 45 N•m) torque.

Fill the grease cap 1/4 full (approximately 1/2 – 3/4 oz.) of grease.

Press the grease cap (Item 1) onto the pulley assembly (Item 2) [Figure 30-60-21]. Press on the outer formed edge of the grease cap.

NOTE: When pressing the grease cap onto the pulley assembly, do not press down on the arrow indicator plate. Support the hub assembly so that it contacts only the hub and not the arrow indicator plate.


Leave a Reply

Your email address will not be published. Required fields are marked *