BOBCAT S130 – CYLINDER (TILT) – Removal And Installation

Remove the attachment. Roll the Bob-Tach forward and lower the lift arms.

Place the Bob-Tach flat on a pallet to allow the tilt cylinder base end pin enough clearance to be removed [Figure 20-21-2].

Stop the engine. Move the tilt pedal to release the hydraulic pressure. Raise the seat bar.

Disconnect both hydraulic hoses (Items 1 & 2) [Figure 20-21-3].

Remove the retainer nut (Item 1) [Figure 20-21-4] from the cylinder rod end pivot pin.

Installation: Tighten the retainer nut to 25 – 28 ft.-lb. (34 – 38 N•m) torque.

Remove the grease fitting from the rod end pivot pin (Item 1) [Figure 20-21-5].

Remove the rod end pivot pin.


Leave a Reply

Your email address will not be published. Required fields are marked *