BOBCAT S130 – CONTROL SYSTEM (ACS) – Handle Sensor Connector Disassembly And Assembly

The wire connector (Item 1) [Figure 60-130-1] can be removed from the handle sensor wires, using the following procedure.

Remove the wedge (Item 1) [Figure 60-130-2] from the connector.

With a pointed tool, lift the tab (Item 1) [Figure 60-130-3] and pull the wire from the connector.

Installation: Install the wires into the connector as listed below [Figure 60-130-3]:
1-Terminal – Red
2-Terminal – Black
3-Terminal – Green


Leave a Reply

Your email address will not be published. Required fields are marked *