BOBCAT S130 – CONTROL SYSTEM (ACS) – Handle Lock Solenoid Removal And Installation

Disconnect the harness connector (Item 1) [Figure 60-130-24] from the handle sensor connector.

Disconnect the harness connector (Item 2) [Figure 60-130-24] from the handle lock solenoid connector.

Remove the two screws (Item 1) [Figure 60-130-25] holding the handle lock solenoid to the handle.

Installation: Tighten the screws to 32 – 38 in.-lb. (3,6 – 4,3 N•m) torque.

Remove handle lock solenoid assembly from handle.


Leave a Reply

Your email address will not be published. Required fields are marked *