BOBCAT S130 – CONTROL SYSTEM (ACS) – Foot Sensor Disassembly And Assembly

Remove the two bolts (Item 1) [Figure 60-130-28] from the end of the foot sensor.

Installation: Tighten the bolts to 90 in.-lb. (10,2 N•m) torque. Apply Loctite® 242 to the threads.

Remove the boot retainer (Item 1), boot (Item 2), spool stop plate (Item 3), O-ring (Item 4) [Figure 60-130-29].

NOTE: Do not disassemble the sensor assembly (Item 5) [Figure 60-130-29]. The sensor assembly is a calibrated assembly and cannot be serviced. Order through Bobcat Parts.


Leave a Reply

Your email address will not be published. Required fields are marked *