BOBCAT S130 – CONTROL PEDALS AND LINKAGES – Pedal Removal And Installation

Raise the lift arms and install an approved lift arm support device.(See Installing on Page 10-20-1.)

Raise the operator cab.(See Raising on Page 10-30-2.)

Remove the bolt (Item 1) [Figure 50-90-1] and nut from the pedal linkage.

Installation: Tighten the bolt and nut to 25 – 28 ft.-lb. (34 – 38 N•m) torque.

Check the rubber bushing in the pedal for wear and replace as needed.

Remove the two mounting bolts (Item 1) [Figure 50-90-2] from the pedal mounting bracket.

Remove the pedal assembly from the loader.


Leave a Reply

Your email address will not be published. Required fields are marked *