BOBCAT S130 – CONTROL PANEL – Shaft Disassembly And Assembly

Disassemble the right and left steering bellcranks (Item 1) from the cross shaft assembly [Figure 50-100-12].
Assembly: Install new nylon bushings (Item 2) [Figure 50-100-12] as needed when assembling the steering shaft. Be sure to apply grease on the cross shaft before installing the right and left bellcranks.

NOTE: The bellcranks should pivot freely on the cross shaft when assembled correctly.

To remove the steering shaft mounting bracket (Item 3) [Figure 50-100-11], remove the three mounting bolts (Item 1) [Figure 50-100-13] from the front of the control panel.

Remove the steering shaft mounting bracket.

Installation: Tighten the mounting bolts to 15 – 20 ft.-lb. (20 – 27 N•m) torque.


Leave a Reply

Your email address will not be published. Required fields are marked *