BOBCAT S130 – CONTROL HANDLE/LEVER (ACS) – Handle Removal and Installation

Remove the handle sensor (Item 1) [Figure 50-111-12]. (See Handle Sensor Removal And Installation on Page 50-111-1.)

Remove the switch handle (Item 1) [Figure 50-111-13]. (See Switch Handle Removal on Page 60-130-4.)

Remove the rubber handle cover (Item 1) [Figure 50-111-14] from the handle.

Using a small screwdriver, hold the handle spacer (Item 1) and remove the allen head screws (Item 2) [Figure 50-111-15] from the handle assembly.

Installation: Tighten the allen head screws to 35 in.-lb. (4 N•m) torque.

 

Leave a Reply

Your email address will not be published. Required fields are marked *