BOBCAT S130 – CHAINCASE – Front Cover Removal And Installation

Raise the loader lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.)

Raise the loader operator cab. (See Raising on Page 10-30-2.)

Remove the front chaincase cover mounting screws (Item 1) [Figure 40-30-1].

Remove the front chaincase cover (Item 2) [Figure 40-30-1] from the loader.

NOTE: There are machined recesses (Item 3) [Figure 40-30-1] on the bottom side of the cover to help pry the covers off.

Installation: Apply polyurethane sealer to mating surfaces. Polyurethane sealant should be applied to the screw threads to stop oil leakage. Tighten the mounting screws to 20 – 25 ft.-lb. (27 – 34 N•m) torque.


Leave a Reply

Your email address will not be published. Required fields are marked *