BOBCAT S130 – BUCKET POSITION VALVE – Removal And Installation

Start the engine. Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.)

Stop the engine.

Raise the operator cab. (See Raising on Page 10-30-2.)

Disconnect solenoid connector harness (Item 1) [Figure 20-110-5].

Disconnect tubelines (Item 1) [Figure 20-110-6] and [Figure 20-110-7] from the A, B, C, and D port.

Disconnect tubeline (Item 1) [Figure 20-110-8] at tee fitting below the Bucket Position Valve.

This line is connected to A port on bucket position valve.

Remove bucket position valve mounting bolts (Item 1) [Figure 20-110-9].

Remove the bucket position valve from the loader.


Leave a Reply

Your email address will not be published. Required fields are marked *