BOBCAT S130 – BOBCAT CONTROLLER (MAIN) – Removal And Installation

Lift and block the rear of the loader. (See Procedure on Page 10-10-1.)

Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.)

Stop the engine. Raise the seat bar.

Raise the operator cab. (See Raising on Page 10-30-2.)

Loosen the harness connectors mounting bolts (Item 1) [Figure 60-70-1] from the Bobcat controller.

Remove the connectors.

Installation: Tighten bolts to 30 – 35 in.-lb. (3,39 – 3,96 N•m) torque.

NOTE: The connectors are keyed and will only plug in one way.

Remove the three mounting bolts (Item 2) [Figure 60-70-2] securing the controller to the frame.

Installation: Tighten the bolts to 12 – 14 ft.-lb. (16,3 – 19 N•m) torque.

Remove the system controller.

Reverse the above procedure to install the system controller.


Leave a Reply

Your email address will not be published. Required fields are marked *