BOBCAT S130 – BATTERY – Removal And Installation

Open the rear door.

Disconnect the negative (-) battery cable (Item 1) [Figure 60-20-1].

Remove the battery hold down clamp (Item 2) [Figure 60-20-1].

Disconnect the positive (+) battery cable (Item 1) [Figure 60-20-2].

Remove the battery from the loader.

Always clean the battery terminals and cable ends when installing a new or used battery [Figure 60-20-3].

When installing the battery in the loader, do not touch any metal parts with the battery terminals.

Install the battery hold down clamp.

Connect the negative (-) cable last to prevent sparks.

Connect and tighten the battery cables.

Close the rear door before operating the loader.


Leave a Reply

Your email address will not be published. Required fields are marked *