BOBCAT S130 – ALTERNATOR – Removal And Installation

Place jackstands under the rear corners of the loader.

Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.)

Raise the operator cab. (See Raising on Page 10-30-2.)

Disconnect the negative (-) cable from the battery.

Disconnect the red wire (Item 1) [Figure 60-30-7] from the alternator which comes from the battery.

Disconnect the wiring harness connector (Item 2) [Figure 60-30-7] from the alternator.

Remove the adjustment bolt (Item 1) [Figure 60-30-8] from the mounting bracket.

Remove the alternator belt (Item 2) [Figure 60-30-8] from the alternator pulley.

Remove the mounting bolt (Item 3) [Figure 60-30-8].


Leave a Reply

Your email address will not be published. Required fields are marked *