BobCat E35 – X-CHANGE (HYDRAULIC) – Removal And Installation

Remove the bucket. (See Operation & Maintenance Manual for the correct removal procedure.)

Support the boom with a hoist (Item 1) [Figure 40-201-1] and release the pressure on the boom cylinder.

Remove the snap rings (Item 1) [Figure 40-201-2].

Remove the washers (Item 1) [Figure 40-201-3].

Remove the plate (Item 1) [Figure 40-201-4].

Remove the two hydraulic hoses (Item 1) [Figure 40-201-5] from the tubelines.

Remove the two pins (Item 1) and link (Item 2) [Figure 40-201-6].

Remove the two nuts (Item 1) and bolt (Item 2). Remove the pin (Item 3) [Figure 40-201-7].
Remove the hydraulic X-Change.

Remove the O-rings (Item 1) [Figure 40-201-8] from the arm.


Leave a Reply

Your email address will not be published. Required fields are marked *