BobCat E35 – TRAVEL MOTOR – Removal And Installation

Lift and block the side of the track frame where the travel motor will be removed.

Release the track tension and remove the track. (See Track Removal And Installation on Page 30-20-4.)

Remove the bolts (Item 1) [Figure 20-70-1] from the track frame cover.

Remove the cover.

Mark the hoses for correct installation.

Remove the hoses (Item 1) [Figure 20-70-2] from the travel motor.

Remove the bolts (Item 1) [Figure 20-70-3] from the travel motor.

Installation: Apply thread lock (Loctite® 242) to the bolts and tighten to 105 – 115 N•m (78 – 85 ft-lb) torque.

Remove the travel motor from the track frame.


Leave a Reply

Your email address will not be published. Required fields are marked *