BobCat E35 – TRACK UNDERCARRIAGE COMPONENTS (RUBBER TRACK) – Adjusting Tension

Loosen the two bolts on the cover (Item 1) [Figure 30-20-5]. Pivot the cover downward.

Add grease to the fitting (Item 1) [Figure 30-20-6] until the track tension is correct.

Use tool MEL1560 (Item 1) [Figure 30-20-6] to loosen the bleed fitting (Item 2) [Figure 30-20-7] to release tension from the track.

NOTE: Do not loosen the grease fitting (Item 2) [Figure 30-20-7].

Repeat the procedure for the other side.

 

Leave a Reply

Your email address will not be published. Required fields are marked *