BobCat E35 – SWIVEL JOINT – Disassembly And Assembly

Remove the snap ring (Item 1) [Figure 20-80-7].

Remove the nylon ring (Item 1) [Figure 20-80-8].

Tap the rotor (Item 1) [Figure 20-80-9] out of the housing.

Continue to remove the rotor (Item 1) [Figure 20-80-10] until the rotor is out of the housing.

Remove the crown seals (Item 1) and remove the seals (Item 2) [Figure 20-80-11].

Assembly: Heat the crown seals and seals in hydraulic oil for three minutes at 54°C (130°F) before installing the seals on the rotor.

 

Leave a Reply

Your email address will not be published. Required fields are marked *