Remove the left handle. (See Handle Removal And Installation on Page 20-120-2.)

Clean the outside of the control lever before disassembly.

Remove the boot (Item 1) [Figure 20-120-14].

Mark the coupler (Item 1), nut (Item 2), and connector (Item 3) [Figure 20-120-15] for ease of assembly.

Loosen the nut (Item 1) and remove the connector (Item 2) [Figure 20-120-16].

Mark the coupler (Item 1), control plate (Item 2), and plate (Item 3) [Figure 20-120-17] for ease of assembly.

Remove the coupler (Item 1) from the control plate (Item 2) [Figure 20-120-18].

Remove the control plate (Item 1) from the U-joint (Item 2) [Figure 20-120-19].

Mark the plate and housing for correct installation.
Remove the U-joint (Item 1) [Figure 20-120-20].

NOTE: The plate (Item 2) [Figure 20-120-20] is spring loaded and will come up as the U-joint is removed.

Remove the plate (Item 1) [Figure 20-120-21].

Remove the plunger assemblies (Item 1) [Figure 20-120-22].

Remove the O-rings (Item 1) and plunger (Item 2) from the bushing (Item 3) [Figure 20-120-23].

Remove the spool assemblies (Item 1) [Figure 20-120-24].

Compress the spring (Item 1) and remove the seat (Item 2) [Figure 20-120-25].

Remove the spring (Item 1) and shim (Item 2) from the spool (Item 3) [Figure 20-120-26].

Remove the springs (Item 1) [Figure 20-120-27] from the housing.

Clamp the housing in a vise that is equipped with padded jaws [Figure 20-120-28].

Remove the two bolts (Item 1) [Figure 20-120-28].

Remove the end cap (Item 1) [Figure 20-120-29].

Remove the O-ring (Item 1) and seal (Item 2) [Figure 20-120-30].


Leave a Reply

Your email address will not be published. Required fields are marked *