BobCat E35 – RECONDITIONING THE ENGINE – Idle Gear And Shaft – Servicing

Measure the O.D. of the idle gear shaft [Figure 60-100-19].

Measure the I.D. of the idle gear bushing [Figure 60-100-19].

If the clearance exceeds the allowable limit, replace the bushing.

To replace the idle gear bushing, make a driver tool as shown in figure [Figure 60-100-20].

Use a press and special driver tool to remove the old bushing and install the new bushing [Figure 60-100-21].


Leave a Reply

Your email address will not be published. Required fields are marked *