BobCat E35 – RECEIVER / DRIER – Pressure Switch Removal And Installation

Open the right side cover.

Evacuate the A/C System. (See Reclamation And Charging With Recovery / Charging Unit on Page 70-40-3.)

Remove the right upperstructure cover. (See Removal And Installation on Page 40-80-1.)

Locate the pressure switch (Item 1) [Figure 70-70-4].

Disconnect the wire harness (Item 2) [Figure 70-70-4] from the pressure switch wire harness.

Remove the pressure switch from the excavator.


Leave a Reply

Your email address will not be published. Required fields are marked *