BobCat E35 – MOTION ALARM SYSTEM – Adjusting Switch Position

The motion alarm switch (Item 2) [Figure 50-130-5] is located in the travel control valve located under the floor plate. Remove the floor mat and the floor plate to access the switch.

The switch (Item 2) [Figure 50-130-5] is non-adjustable.
It must be fully installed into the travel control valve housings and tightened. Tighten the switch to 18 – 20 N•m (13 – 15 ft-lb).

Inspect the motion alarm system for proper function after switch replacement.


Leave a Reply

Your email address will not be published. Required fields are marked *