BobCat E35 – LUBRICATION SYSTEM – Engine Oil Pressure – Testing

Remove the oil pressure sender.

Install a pressure gauge [Figure 60-60-7].

Start the engine and run until it is at operating temperature.

If the oil pressure is less than the allowable limit, check the following items:

* Engine Oil Level Low
* Oil Pump Defective
* Oil Galley Plugged
* Oil Strainer Plugged
* Excessive Clearance at the Rod And Main Bearings
* Oil Pump Relief Valve Stuck

 

Leave a Reply

Your email address will not be published. Required fields are marked *