BobCat E35 – LEFT CONSOLE – Upper Console Cover Removal And Installation

Remove the screw (Item 1) [Figure 40-60-2] and lower the console.

Remove the screw (Item 1) [Figure 40-60-3] from the rear of the cover.

Pull up on the center of the plastic fastener (Item 1) [Figure 40-60-4].

Remove the fastener assembly (Item 1). Remove the bolts (Item 2) and nuts. Remove the arm rest (Item 3) [Figure 40-60-5].

Pull down on the front of the bottom cover (Item 1) [Figure 40-60-6].

Installation: Push up on the bottom cover until the lock tabs (Item 1) [Figure 40-60-7] engage the slots (Item 2) [Figure 40-60-6].

Pull up on the rear of the top cover (Item 1) [Figure 40-60-8].

Installation: Push down on the top cover until the lock tabs (Item 1) engage the slots (Item 2) [Figure 40-60-9].

Disconnect the wire harness from the switches and remove the top cover (Item 1) [Figure 40-60-10].


Leave a Reply

Your email address will not be published. Required fields are marked *