BobCat E35 – LEFT CONSOLE – Compression Spring Removal And Installation

Remove the lower console cover. (See Lower Console Cover Removal And Installation on Page 40-60-1.)
Lower the console.

Install a pin (Item 1) [Figure 40-60-11] in the bottom of the compression spring rod.

Support the console in the raised position. Remove the bolt and roller (Item 1) [Figure 40-60-12].
Lower the console and remove the pin from the rod.
Raise and support the console.

Remove the nut (Item 1) [Figure 40-60-13].

Remove the bolt (Item 1) and bushing (Item 2). Remove the spring assembly (Item 3) [Figure 40-60-14] from the console.

Remove the bushing (Item 1) [Figure 40-60-15] from the bottom of the console.

Remove the spring (Item 1) from the shaft (Item 2) [Figure 40-60-16].

Remove the sleeve (Item 1) and washer (Item 2) from the shaft (Item 3) [Figure 40-60-17].


Leave a Reply

Your email address will not be published. Required fields are marked *