BobCat E35 – INSTRUMENT PANEL (S/N A93K18000 & ABOVE AND AC2P15000 & ABOVE) – Removal And Installation

Pull up on the center pin (Item 1) [Figure 50-101-2].

Remove the pin assembly (Item 1) [Figure 50-101-3].

Pull up on the instrument panel (Item 1) [Figure 50-101-4].

Installation: Install the tabs (Item 1) into the cover (Item 2) [Figure 50-101-5].

Disconnect the wire harness from the instrument panel [Figure 50-101-6].

Remove the screws (Item 1) [Figure 50-101-7] and remove the instrument panel.


Leave a Reply

Your email address will not be published. Required fields are marked *